Home
Главная
Brayer
Термопоты
1092BR
Инструкция по эксплуатации Страница: 8

Brayer 1092BR Инструкция по эксплуатации онлайн [8/44] 795018

• After long water boiling the thermopot will switch to

the keep warm mode, the indicator (16) «Boiling» will

go out and the keep warm mode indicator (17) «Keep

warm» will glow constantly.

Notes: the thermopot uses a long boiling technology

which signicantly reduces the chlorine level in water.

• To avoid burns by hot steam, do not bend over the

steam release openings (7) in the thermopot lid (4).

Do not block the steam release openings (7) with any

objects.

• Drain the water after the rst boiling. Hot water

resulting from the rst boiling is not recommended to

consume, you may use it for domestic needs.

ATTENTION!

Be careful when pouring out water to avoid burns

by hot water.

• To drain the water you can do the following:

First option: place a suitable bowl, for instance, a cup

under the spout for pouring water (2) and press

• the water dispense button with a rim of the cup (pic.

3).

Second option: place a suitable bowl under the spout

for pouring water (2) and press the water dispense

button (19) «Water dispense» (pic. 4).

Third option:

- in case of power cut use the hand pump (6);

- remove the hand pump lock by setting the block (8) to

the position «

»;

- place a suitable bowl under the spout for pouring water

(2);

- press the hand pump (6), the water will be pouring

from the spout (2);

- after you nish pouring water, set the block (8) to the

position «

» (pic. 5).

• To switch the thermopot o disconnect the power

cord (20) plug from the mains socket.

• Open the thermopot lid (4) and wait until it cools

down completely.

• Always drain the remaining water from the thermopot

ask, to do this remove the lid (4).

• Before removing the lid (4) open it, press on the lock

(15) above, take the button (5) and remove the lid (4)

by pulling it towards the control panel (3) (pic. 6).

• Carefully tilt the thermopot to drain the remaining

water (pic. 7).

• Install the lid (4) back to its place. To do this, set the

lid (4) at a small angle, press the lock (15) and insert

the lid (4) to its installation place. Release the lock

(15). Before using the thermopot make sure that the

lid (8) is xed properly with the lock (15).

Brayer 1092BR Инструкция по эксплуатации онлайн [8/44] 795018

Содержание

Похожие устройства