Home
Главная
Brayer
Термопоты
1092BR
Инструкция по эксплуатации Страница: 9

Brayer 1092BR Инструкция по эксплуатации онлайн [9/44] 795018

Brayer BR1092 Инструкция по эксплуатации онлайн [9/44] 542961

Additional information

• The thermopot is equipped with rotating base (12).

You can turn the thermopot body (10) in the required

direction.

• Check the water level in the thermopot using the

scale (1).

• Timely rell the thermopot.

• If the water temperature goes signicantly below

the preset temperature (for example, if you added

cold water), the boiling mode will switch on and the

indicator (16) «Boiling» will light up.

• You can switch the reboiling mode on by pressing the

button (18) «Reboiling», the indicator (16) «Boiling»

will light up. After boiling the water the indicator (16)

«Boiling» will go out and the keep warm mode will

switch on.

CLEANING AND MAINTENANCE

• Before cleaning the thermopot unplug it, open the

lid (4) and wait until the thermopot cools down

completely.

• Always drain the remaining water from the thermopot

ask, to do this remove the lid (4).

• Before removing the lid (4) open it, press on the lock

(15) above, take the button (5) and remove the lid (4)

by pulling it towards the control panel (3) (pic. 6).

• Carefully tilt the thermopot to drain the remaining

water (pic. 7).

• Install the lid (4) back to its place. To do this, set the

lid (4) at a small angle, press the lock (15) and insert

the lid (4) to its installation place. Release the lock

(15). Before using the thermopot make sure that the

lid (8) is xed properly with the lock (15).

• Clean the outer surface of the thermopot body (10)

with a slightly damp cloth and then wipe it dry.

• Use neutral detergents to remove dirt, do not use

metal brushes, abrasives and solvents.

• Do not immerse the thermopot and the power cord

(20) into water or other liquids.

• Do not put the thermopot in a dishwashing machine.

Stains on the inner surface of the thermopot ask

• Water contains various minerals that can cause

stains on the inner surface of the thermopot ask, the

stains do not aect the operation of the thermopot,

stains are not covered by the warranty.

• You can remove the stains from the inner surface of

the thermopot ask with citric acid solution or table

vinegar.

• To remove the avour of citric acid or vinegar, boil

water and pour it out.

• Repeat this procedure until the smell and foreign

taste vanish completely.

Removing the mineral deposits (descaling)

• Scale, appearing inside the thermopot ask,

inuences the water taste and disturbs the heat

exchange between water and the heating element.

Brayer 1092BR Инструкция по эксплуатации онлайн [9/44] 795018

Содержание

Похожие устройства