Brayer BR1035 [7/40] Using the electric kettle
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Brayer BR1035 [7/40] Using the electric kettle

Brayer BR1035 [7/40] Using the electric kettle
7EN
STANDBY MODE.
• Plug the power cord into an electrical outlet, then 2 beeps
will sound and the temperature of the water in the ask
(1) of the kettle will be displayed in digital symbols (13).
• Press the On/O󰀨 button (10) « », then a beep signal
will sound, and the water heating temperature will
be shown in displayed symbols (13). When the water
temperature reaches 100°C, beeps will sound, the water
boiling indicator (12) and the heating indicator will light
up, and the kettle heating element will turn o󰀨.
• Press the button (5) to open the cover (4).
• Remove the kettle from the base (7) and carefully pour
out boiled water into a suitable bowl.
• Remember that there is boiling water inside the kettle
ask (1), always hold the kettle only by the handle (6),
do not tilt the kettle sharply, in case of careless use of the
kettle you can get burns by hot water.
• Repeat the water boiling procedure several times.
ATTENTION! To avoid burns by hot steam, do not bend
over the spout (3).
• Hot water resulting from the rst boilings is not recommended
to consume, you may use it for domestic needs.
USING THE ELECTRIC KETTLE
• Place the kettle on a solid steady at and non-slip non-
metal surface away from heat sources as far as possible
from the edge of the surface.
WATER BOILING
• Take the handle (10), pull it upwards and remove the lid (9).
• Fill the kettle with water not lower than the «MIN» mark
and not higher than the «MAX» mark on the scale (9)
located on the inner surface of the ask (1).
• Close the lid (4) and place the kettle lled with water on
the kettle stand (7).
Note: always make sure that water drops do not fall on the
contact unit of the kettle stand (7).
• Plug the power cord into an electrical outlet, then 2 beeps
will sound and the temperature of the water in the ask
(1) of the kettle will be displayed in digital symbols (13).
• Press the On/O󰀨 button (10) « », then a beep will
sound, and the water heating temperature will be shown
in displayed symbols (13). When the water temperature
reaches 100°C, beeps will sound, the water boiling
indicator (12) and the heating indicator will light up, and
the kettle heating element will turn o󰀨.When the water
starts boiling, you will hear sound signals, the button
«100°С» illumination will glow blue, the «ON/OFF» button
(3) illumination will glow green.
• If it is necessary to switch the kettle o󰀨, press the On/O󰀨
button (10) «ON/OFF».
Notes:
- after water boiling, droplets may appear on the surface
of the stand (7) due to steam condensation. This is a
normal phenomenon and is not a warranty case;
- The digital symbols (13) showing temperature of the

Содержание

Похожие устройства

Скачать