Brayer BR4882 [9/76] Remote control rc

Brayer BR4882 [9/76] Remote control rc
9EN
To avoid mains overloading, do not switch on several
electrical appliances with high power consumption at
the same time.
Insert the power plug into the mains socket.
REMOTE CONTROL (RC)
The control buttons on the remote control are similar to
the control buttons on the control panel (3).
Attention! A lithium battery is used in the remote
control. Prevent children from swallowing the lithium
battery. If your child has swallowed a battery, seek
immediate medical advice.
Press the latch on the side and remove the battery
holder (30), install a CR2025 battery, strictly following
the polarity.
Install the battery holder (30) to its place.
Notes:
- If there is an insulating gasket in the RC battery
compartment, remove the gasket.
- replace the battery in time;
- do not recharge the lithium battery;
- remove the battery if you are not going to use the
appliance for a long time;
- remove the used battery from the remote control
(22) and dispose of it.
When using the remote control, point it at the front of
the convection fan heater.
The distance between the remote control and the
appliance should not exceed 5 m, the coverage angle
should be up to 30 degrees.
Avoid direct sunlight on the remote control signal
receiver (14), otherwise false switching on of control
commands is possible.
BATTERY REPLACEMENT
Remove the battery holder (30), remove the old
battery, install a new CR2025 battery strictly following
the polarity, install the battery holder (30) into the
remote control.
DESCRIPTION OF THE POWER BUTTON AND
THE BUTTONS ON THE CONTROL PANEL (3)
Power switch (5) «ON/OFF». Set the switch (5) to
the «ON» position to power on the appliance. At the
end of operation, turn the appliance o󰀨 by setting the
switch (5) to the «OFF» position.
Note: - operating mode buttons on the control panel (3)
are touch-sensitive, and it is enough to touch the button
to switch on the desired operating mode; each touch
of the active button will be accompanied with a sound
signal.
On/O󰀨 button (7) « ». Touch the button (7)
« » once or press the button (23) « » on the
remote control (22) to turn on the convection fan
heater. To turn the appliance o󰀨, touch the button (7)
« » again or press the button (23) « ».

Содержание

Похожие устройства

Скачать
Случайные обсуждения