Vitek Aquamarine VT-1353 [8/60] English

ENGLISH

To remove the attachment comb press the clamp and

remove the attachment.

Step one

Install the attachment comb (5) or (6) (pic. 1).

Switch the hair clipper on using the power switch (4),

setting it to the upper position. Hold the hair clipper with

the blades (1) pointed upwards. Start cutting from the

hair growth edge. Slowly move the hair clipper upwards.

This way cut all hair at the bottom of the back of the head

and near the ears.

Step two

Switch the hair clipper off with the power switch (4) by

setting it to the lower position, unplug the unit, then set

the attachment comb (7, 8, 9) or (10) for longer hair and

continue cutting hair near top of the head.

Step 3 – cutting in the temples area

Switch the hair clipper off and unplug it, then set the

attachment comb (5) or attachment comb (6) and cut

hair in the area of temples. Then set the 9 mm attachment

comb (7, 8, 9) or attachment comb (10) and continue

cutting towards the top of the head.

Step 4 – cutting the crown of the head

Using the attachment comb (7, 8, 9) or attachment comb

(10), cut the hair on the top of the head towards the crown

against the hair growth direction.

• You can cut hair against and along the direction of hair

growth, but keep in mind that the hair cut against the

growth will be shorter than the hair cut along the growth.

• Use the attachment comb (5) and attachment comb

(6) for very short haircut. To leave a little longer hair,

use the attachment comb (7, 8, 9) or attachment

comb (10).

• To leave longer hair, grip hair locks between your fin-

gers and cut the hair off using the clipper.

• You may use a comb: lift the hair locks and cut them

with the hair clipper above the comb.

• Always start cutting from the head back.

• Comb the hair with a comb to reveal uneven locks.

• Use the scissors to make haircut even.