Home
Главная
Rondell
Электрические Чайники
RDE-1002 черный
Инструкция по эксплуатации Страница: 6

Rondell RDE-1002 черный [6/24] English

ENGLISH

–

Close the lid (4) and put the kettle on the base (9). Make

sure that the kettle lid is closed tightly.

–

Close the lid (4) and put the kettle on the base (9). Make

sure that the kettle lid is closed tightly.

–

Select the desired temperature «60°C-70°C-80°C-90°C-

100°C» by turning smoothly the temperature control knob

(7) clockwise.

–

Connect the power plug to the mains socket, the on/off

button (8) illumination will light up blue, and the indicator

(11) will light up under the preset water temperature value.

The kettle will switch to the standby mode.

Water boiling

–

Select the temperature 100°C by turning smoothly the

temperature control knob (7) clockwise.

–

Switch the kettle on by touching the on/off button (8)

« » for a short time, you will hear a short sound signal,

the on/off button (8) illumination will light up blue, and

the indicator (11) will light up under the preset water tem-

perature value.

–

After the water boils, you will hear three short sound sig-

nals, the heating will be switched off, the on/off button

(8) illumination will go out and the kettle will switch to the

standby mode.

Water heating to a preset temperature

–

Touch the on/off button (8) « » for a short time, you will

hear a short sound signal and the water heating will start.

Select the desired temperature «60°C-70°C-80°C-90°C»

by turning smoothly the temperature control knob (7)

clockwise. When the preset temperature is reached, the

water heating will stop, you will hear three short sound

signals, the on/off button (8) illumination will go out and

the kettle will switch to the standby mode.

Note: when the desired heating temperature is selected,

you can also turn the control knob (7) counterclockwise.

Dry boil protection

–

If you accidentally switch the kettle on, but the water level

appears to be below the minimal mark, the automatic

thermal switch will be on and the kettle will be switched

off and all symbols will go out. In this case take the ket-

tle from the base (9), let it cool down for 10-15 minutes,

then fill it with water and switch it on, the kettle will oper-

ate in normal mode.

Note:

–

There is a power cord storage (10) on the reverse side

of the base (9). Adjust the optimal power cord length by

folding it in a corresponding way.

CLEANING AND MAINTENANCE

–

Before cleaning disconnect the unit from the mains, pour

out water and let the kettle cool down.

–

Wipe the outer surface of the kettle with a damp cloth or

a sponge. Use soft detergents to remove dirt; do not use

metal brushes and abrasive detergents.

–

Regularly clean the mesh filter (3) from dirt with a soft

brush.

–

Do not immerse the kettle and the base into water or any

other liquids.

–

Do not wash the kettle and the base in a dishwashing

machine.

Note:

–

to remove the mesh filter, press the clamp located in its

upper part.

–

when installing the mesh filter, insert its lower part to the

installation place first, and then its upper part, and press

it slightly until it is fixed properly.

Descaling

–

Scale, appearing inside the kettle, influences the water

taste and disturbs the heat exchange between water and

heating element and leads to overheating of the heat-

ing element and its malfunction. Burning of the heating

element caused by the scale in the kettle is not covered

by warranty.

–

To remove scale, fill the kettle with water by about 75%

and then boil the water up. Fill the remaining quarter of

the flask with vinegar solution (6-9%) and leave the liq-

uid in the kettle overnight (for approximately 8 hours).

In the morning pour the vinegar mixture out of the kettle

and rinse the flask several times. To remove the remain-

ing vinegar and its smell, boil the kettle filled with ordinary

water once or twice.

–

If necessary, repeat the cleaning cycle.

–

You can use special detergents for electric kettles to

remove scale.

–

Clean the kettle from scale regularly.

Attention! The warranty does not cover breakdown or mal-

functioning of the unit caused by uncleaned scale.

STORAGE

–

Before taking the unit away for long storage, unplug it,

pour out water and let the unit cool down.

–

Clean the kettle.

– Fix the power cord in the cord storage (10) on the

base (9).

–

Keep the kettle in a dry cool place away from children and

people with disabilities.

Rondell RDE-1002 черный [6/24] English

Содержание

Похожие устройства