Scarlett SC-MG45S74 [4/12] Place the meat on the hopper tray and feed it into the meat grinder little by little with the pusher

Scarlett SC-MG45S74 [4/12] Place the meat on the hopper tray and feed it into the meat grinder little by little with the pusher
IM023
www.scarlett.ru SC-MG45S74
4
In case of power cord is damaged, its replacement should be done by the manufacture or service
department or the other high-skill person to avoid any danger.
Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the
malfunctioning appliance in the nearest service center only.
Keep the cord away from sharp edges and hot surfaces.
Do not pull, twist, or wrap the power cord around the appliance.
Do not place the appliance near gas or electric oven or store at heated surface.
Avoid contacting with moving parts.
The blades are very sharp, so handle them with care.
Do not push products into the appliance with fingers while it is in operation. If food becomes lodged
in the feeder tube, use the pusher to push it down. If this doesn’t work, turn the motor off, unplug
the unit, and then disassemble the appliance to remove remaining food.
When carrying the unit be sure to hold the motor housing with both hands. Do not carry the unit
by the hopper plate or head.
Do not fix the cutting blade and cutting plate when using kebbe attachment.
Do not grind hard food such as bones, nuts, ginger or other products with hard fiber.
When the circuit breaker activates, do not switch on.
Do not run the meat grinder continuously for longer than 7 minutes. Turn the unit off and let
it rest for at least 7 minutes to cool down the motor, otherwise the motor may be damaged.
Be sure to turn the appliance off after each use. Make sure the motor stops completely before
disassembling.
Do not overload the appliance with products.
If the product has been exposed to temperatures below 0ºC for some time it should be kept at
room temperature for at least 2 hours before turning it on.
The manufacturer reserves the right to introduce minor changes into the product design without
prior notice, unless such changes influence significantly the product safety, performance, and
functions.
Manufacturing date is indicated on the unit and/or on packing as well as in accompanying
documents in the following format XX.XXXX where first two figures XX is the month of
production, and following four figures XXXX is the year of production.
BEFORE THE FIRST USE
Wash all parts (except body) in warm soapy water.
Before plugging in, ensure the appliance is switched off.
INSTRUCTION FOR USING
ASSEMBLING
Place the head tightly onto the head inlet.
Place the snake into the head, long end first, and turn to feed the screw slightly until it is set into
the motor housing.
Place the cutting blade onto the snake shaft with the blade facing the front as illustrated. Place
the desired cutting plate next to the cutting blade, fitting protrusions in the slots. If it is not fitted
properly, meat will not be ground.
Screw the fixing ring tightly. Do not overtighten.
Place the feed tray on the head and fix it into position.
Locate the unit on a firm surface.
The air passage at the bottom and the side of the motor housing should be kept free and not
blocked.
PROCESSING MEAT
Cut the meat into pieces so that they easily fit the throat.
Plug the meat grinder in and set the switch to the ON position.
Place the meat on the hopper tray and feed it into the meat grinder little by little with the pusher.
After finishing work switch off the meat grinder and unplug it from outlet.
MAKING KEBBE
Kebbe is a traditional Middle Eastern dish. It is usually prepared of lamb and bulgur minced
together to smooth paste. Paste is formed to hollow tubes, stuffed with mixture of meat and
spices and then deep-fried.
Feed the prepared minced meat through the kebbemaker.
Cut the resulting tube into cylinders of desired length.

Содержание

Скачать