Ada ARMO 2D GREEN Professional Edition А00575 Инструкция по эксплуатации онлайн [5/20] 818924

OPERATION

1. Open battery compartment. Insert batteries. Take care to correct po-

larity. Close battery compartment. Note: Remove batteries, if you are not

going to use the tool for a long period of time.

2. Power supply. It’s possible to use a power supply when working with the

line laser. If rechargeable batteries are used as a power supply, you can

charge them with the help of a charger.

WARNING: Never use charger for ordinary batteries. Do not leave the in-

strument unattended while using charger. Parameters of the charger must

correspond to the parameters of domestic electricity. Output voltage must

be no more than 5V.

3. Place line laser on the oor, magnet target or tripod. When using tripod/

magnet mount, place the line laser on the tripod/magnet mount and screw

the centering screw into the center hole.

4. Switch on the line laser setting the handle (4) to the low position. Always

set the handle to the up position during transportation. If laser lines begin

to blink when switching on the line laser, that means the line laser is out of

range more than ±4º. Level the line laser.

5. Choose the laser lines by pressing button H (9): vertical line only, hori-

zontal line only, both vertical and horizontal lines. Press and hold button

H (9) more than 5 sec to choose the slope mode. Laser line indicator (11)

will turn red. Line laser gives a signal one time per 10 sec. in this mode.

Press and hold button H (9) more than 5 sec to leave this mode. Laser line

indicator (11) will turn green.

6. Use laser glasses (are not supplied with the tool) or switch on the receiv-

er mode during operation in bright light, if the beam is poorly visible. Press

button (10) to switch on the receiver mode. Laser lines indicator is ON. La-

ser beam can be detected with the receiver (is not supplied with the tool).

To switch O the mode, press button (10) once again. Indicator (11) is o.

7. To switch o the line laser, move the switch on handle (4) into the upper

position.

English