Home
Главная
LAVOR PRO
Бензиновые
THERMIC 2W 13 L 0.066.0037
Инструкция к Lavor PRO THERMIC 2W 13 L 0.066.0037 Страница: 19

LAVOR PRO THERMIC 2W 13 L 0.066.0037 Инструкция к Lavor PRO THERMIC 2W 13 L 0.066.0037 онлайн [19/164] 830847

• lance hose;

• bag of accessories with:

- the operating and maintenance manual;

- the engine operating and maintenance manual;

- the declaration of conformity;

- the booklet giving the assistance centres;

- the warranty certicate;

- suction kit with: tting, gasket and clamp;

- nozzle cleaning needle;

If any problems arise please contact your dealer or an authorised assistance centre.

OPTIONAL ACCESSORIES

You can add the following range of accessories to the standard ones supplied with your high pressure

cleaner:

• sandblasting lance: designed to smooth surfaces, removing rust, paint, encrustations, etc.;

• drain cleaning kit: designed to unclog pipes and ducts;

• dierent types of lances and nozzles;

• rotating brush: designed for cleaning fragile surfaces;

• rotating nozzle: designed for removing stubborn dirt;

• foam lance: designed for a more ecient distribution of the detergent;

INSTALLATION - ASSEMBLING THE ACCESSORIES

AND FILLING THEENGINE CRANKCASE WITH OIL

• Unwind the high pressure hose (30) and screw the end without the quickt coupling onto the spray

gun(19) thread and tighten well with two 22 mm xed jaw spanners (not supplied). OperationB in Fig.4.

• Connect the quickt coupling(34) to the water outlet tting(15), screw down and tighten the ring nut

by hand. OperationC in Fig.4.

• Insert the water inlet lter(39) in the water inlet tting (16). OperationD in Fig.4.

• Fill the engine crankcase with oil, following the instructions given in the relevant operating and

maintenance manual (this is not to be done on machines with Diesel engines as they are lled with

oil in the factory).

OPERATION – PRELIMINARY ACTIVITIES

• Do the preliminary activities described in the operating and maintenance manual of the engine

mounted on the high pressure cleaner. In particular remember to ll with fuel and check the level of

engine oil.

• When the engine is o and the machine is completely cold, check the level of pump oil by way of the

level indicator(38). Also check the gearbox oil level by way of the level indicator (44) on those models

thus equipped.

When topping up is needed please refer to the lubricant types given in the

“speCiFiCations and teChniCal

data”

paragraph.

• Check correct tyre ination.

• Check that the inlet water lter(39) and the detergent suction lter(40) are clean.

• Take the high pressure cleaner to the place of work using the handle(4).

• Unwind the high pressure hose completely(30).

• Connect a gardening type quickt coupling to the water inlet hose-end tting(39). OperationG in

Fig.4.

• Start the engine, referring to the relevant operating and maintenance manual.

• Open the water supply tap (if connected to the drinking water mains it is mandatory to use a back-ow

preventer: to use this device refer to the relevant instruction manual), making sure there are no drips.

Alternatively, put a suction hose in a tank.

LAVOR PRO THERMIC 2W 13 L 0.066.0037 Инструкция к Lavor PRO THERMIC 2W 13 L 0.066.0037 онлайн [19/164] 830847

Похожие устройства