Crown CT20114 Инструкция к Crown CT20114 онлайн [7/118] 832159

4. When the engine is cool, move the choke lever to the closed position. Fig. 1a. Primer

5. Set the ignition switch to the" I "position. Fig. 2

a.Throttle lever b. Ignition switch c."exposition d."l"position

6. While holding the unit firmly, pull out the starter rope quickly until engine fires. Fig. 3

л IMPORTANT. Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter

failures.

7. Move the choke lever downward to open the choke, and restart engine.

8. Allow the engine to warm up for a several minutes before starting operation.

NOTE

1. When restarting the engine immediately after stopping it, leave the choke open.

2. Over choking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts,

open the choke and repeat pulling the rope, or remove the spark plug and dry it.

Stopping engine

1. Release the throttle lever and run the engine for half a minute.

2. Shift the ignition switch to the "O" position. Fig. 2

A IMPORTANT.

• Except for an emergency, avoid stopping the engine while pulling the throttle lever.

• If the engine won't stop when setting the ignition switch to the stop position, close the choke lever and stop the

engine.

• In this case, please repair the machine at your nearest servicing dealer.

Cutting work

A WARNING

• Weather conditions and altitude may effect carburation.

• Do not allow anyone to stay close to the hedge trimmer while working or while adjusting the carburetor.

How to use the handle

To reduce fatigue when trimming hedges, the handle can be swiveled through 90° to the left or right.

Do not press the throttle during this operation!

Proceed as follows:

1. Free the handle by pressing the locking lever.

2. Turn the handle until the locking lever clicks into place.

3. When the handle is locked in its new position, you can apply the

throttle again.

You can swivel the handle even with the engine idling because the

hedge-trimmer is equipped with a blade brake that maintains the blades

at a standstill.

HEDGE TRIMMING TECHNIQUES

Trim sides of a hedge first, and then the top.

Vertical

cut

With the 2-sided blade model THT245D use an arcing cut from the bottom upwards, then downwards to use both sides of the

blades. Fig. 4

Fig. 4