Home
Главная
Briggs & Stratton
БЕНЗИНОВЫЕ СНЕГОУБОРЩИКИ
S 1024 1696618
Инструкция к Briggs&Stratton S 1024 1696618 Страница: 12

Briggs & Stratton S 1024 1696618 Инструкция к Briggs&Stratton S 1024 1696618 онлайн [12/252] 832276

Not for

Reproduction

5. Put the unit on a level surface.

6. Clean the oil fill area.

7. Remove the dipstick (A, Figure17).

8. Slowly add oil into the oil fill tube (B). See Specifications

for the oil capacity. 

9. Wait one minute. Check the oil level again.

10. When the oil level touches the top of the full indicator (C),

install and tighten the dipstick.

Adjusting the Skid Shoe Height

DANGER

This snowthrower contains a rotating auger that collects

snow. Fingers can quickly become caught and can result in

a traumatic amputation or a severe laceration.

• STOP the engine. Wait for all moving parts to stop.

Remove the ignition key or push/pull key before

maintenance or repairs.

WARNING

If hit by the auger or impeller, objects such as gravel, rocks,

or other unwanted material can be thrown with sufficient

force and cause personal injury, property damage, or

damage to the snowthrower.

The skid shoes are on each side of the auger housing.

They can be adjusted to increase or decrease the distance

between the scraper bar and the surface to be cleared.

Set the skid shoes at the correct height to maintain ground

clearance for the type of surface being cleared.

1. STOP the engine. Remove the ignition key or push/pull

key.

2. Find the scraper bar clearance needed for the surface to

be cleared.

• To remove snow from hard surface areas, adjust the

skid shoes up to lower the scraper bar closer to the

surface.

• To remove snow from gravel-covered or uneven

surfaces, adjust the skid shoes down to raise the

scraper bar further from the surface. This will help

prevent rocks and other unwanted materials from

being picked up and thrown by the auger and

impeller.

3. Put the unit on a level surface.

4. Loosen the mounting nuts (E,Figure18) on the skid

shoe(H).

5. Under each end of the scraper bar, put a wooden block

(y, z, Figure19)of the same thickness at the desired

clearance height.

Briggs & Stratton S 1024 1696618 Инструкция к Briggs&Stratton S 1024 1696618 онлайн [12/252] 832276

Похожие устройства