Briggs & Stratton S 1024 1696618 Инструкция к Briggs&Stratton S 1024 1696618 онлайн [8/252] 832276

Not for

Reproduction

7. On rewind start models, hold the starter cord handle (F)

tightly. Pull the handle slowly until resistance is felt, then

pull rapidly.

WARNING

Rapid retraction of the starter cord (kickback) will pull your

hand and arm toward the engine faster than you can let go.

Broken bones, fractures, bruises, or sprains could result.



8. On electric start models, connect the extension cord

(G, Figure7) to the starter box (H), and then to the wall

receptacle. Push the starter box button (I). After the

engine starts, disconnect the extension cord from the wall

receptacle and then from the starter box.

WARNING

Damaged or non-grounded power cords could cause

electric shock. Electric shock could cause severe burns or

death.

• Use only a three-conductor power cord that is

correctly grounded to the power source.

• If the extension cord is damaged, the manufacturer

or its service agent or an equivalent qualified person

must replace it.

Note:To extend the life of the starter, use short, start cycles

at a maximum of five seconds. Wait one minute between start

attempts.

9. Let the engine warm for several minutes. Gradually move

the choke control (D) to the OPEN position.

Stop the Engine

1. Turn the ignition key (A, Figure8) to the OFF

position.Remove the ignition key or the Push /Pull key, if

equipped.

2. Keep the key in a safe location out of the reach of

children. The engine cannot start without the key.

Adjust the Discharge Chute and

Deflector

WARNING

Ice, gravel, or other unintended objects can be picked up

by the auger and thrown from the chute with force.Objects

thrown from the chute could cause death, serious injury, or

property damage.