Instrumax CONSTRUCTOR 360 4V IM0122 Инструкция по эксплуатации онлайн [5/32] 834243

vertical lines.

6. During transportation move the switch (3) into position OFF.

Place the instrument into the soft bag or case. Do not drop the

instrument during transportation.

Application of the detector

Use detectore mode when operating in

bright sunlight. Press button (3) to activate this mode. Place

the detector to the approximate location of the beam. Follow

the instruction while searching

laser beam.

To check the accuracy of line laser level

To check the accuracy of line laser level (slope of plane)

Place laser level on the tripod 5m away from the wall so the

horizontal laser line will be directed to the wall. Switch on

the power. The instrument starts to self-level. Mark point A on

the wall to show the contact of laser beam with the wall. Turn the

instrument by 90° and mark points В, С, D on the wall. Measure

distance “h” between the highest and lowest points (these are A

and D points in the picture). If “h”is ≤ 6 mm, the measurement

accuracy is good. If “h” exceeds 6 mm, apply service center.

To check plumb

Choose a wall and set laser 5 m away from the wall. Hang

a plumb with the length 2.5 m on the wall. Turn on the

laser and make the vertical laser line meet the point of

the plumb. The accuracy of the line is in the range if the

vertical line doesn’t exceed (up or down) the accuracy that

is shown in the specifications (±3 mm/10 m). If the accu-

racy isn’t corresponding with claimed accuracy, contact the

authorized service center.

Note: Because of construction of laser emitter laser beam

may be unhomogeneous and has different intensity of

brightness along the perimeter in different light conditions.

Unhomogeneous of laser beam: laser patch of light but

the center of laser beam is identified. Different laser beam

brightness: difference of intensity is up to 50%.

Care and cleaning

Please handle measuring instrument with care. Clean with

soft cloth only after any use. If necessary damp cloth with

some water. If instrument is wet clean and dry it carefully.