Home
Главная
Philips
Вертикальные
AWH1623/51(100YC)
Инструкция по эксплуатации Страница: 16

Philips AWH1623/51(100YC) Инструкция по эксплуатации онлайн [16/46] 857537

Philips AWH1623/51(100YC) Инструкция по эксплуатации онлайн [16/46] 857537

14

лампочка - индика

тор работы УЗО (1)

кнопка TEST (2)

кнопка перезапуска (3)

отверстие сброса давления

винт

ручка слива

7

1. Never drain water if its temperature is

above 50 °C, as this may cause burns.

2. If water does not ow, the valve is

damaged. In this case, the water heater

must not be used and it is recommended

to call a service technician.

Service

1. Check the electrical plug and socket

as often as possible. Reliable electrical

contact must be ensured, as well as

proper grounding. The plug and socket

must not become excessively hot.

2. If the water heater is not used for a long

time, especially in regions with low air

temperature (below 0°C), to prevent

damage to the water heater (due to freezing

of water in the internal tank), the water from

the heater should be drained.

3. To ensure reliable operation of the water

heater for a long time and maintain

warranty obligations, it is recommended

that regular maintenance by specialists

of authorized service centers is

recommended, during which the internal

tank is cleaned, salt deposits are removed

from the electrical heating elements of

the water heater, and the condition of

the magnesium anode is checked, in case

consumption of half or more is replaced.

The frequency of maintenance of the

water heater depends on the hardness of

the water in the area. Possible intervals

from 3 months to a year.

The frequency of cleaning the tank depends

on the hardness of the water. Cleaning must

be carried out by authorized service centers.

In the warranty card, a note is required that

maintenance is carried out at least once

every 12 months.

4. Preventive work must be carried out

with strict observance of the operating

instructions and safety precautions by

specialists of authorized service centers.

5. In case of water overheating, the thermal

biopolar fuse breaks the electrical circuit on

both sides of the heating element. In this

case, determine the cause of overheating

and reset the thermostat manually by

pressing the reset button located on the

thermostat (or, in case of a malfunction,

replace the thermostat).

6. Remember to check the operation of the

safety valve every 14 days. Check method:

– move the drain handle to the upper

position until you feel the transition of

the thread, and then water should ow

from the valve hole.

After checking the water ow, return the

handle to the previous position.

7. Check periodically for scale and blockage.

Drainage of the valve, in order to avoid

clogging, is carried out as follows: if the

valve has a lever, then it must be lifted

several times, if the valve is without a

lever, it must be unscrewed and scale

accumulations removed.

Attention!







Похожие устройства