Sven MS-908 [18/20] Multimedia speaker system

ENG

2.1 Multimedia Speaker System

Cause

The MSS isn’t connected to the mains outlet.

Power switch is o.

Volume level is set at minimum value.

Improperly connected audio source.

Volume level is set at minimum value.

Large amplitude of the input signal.

Solution

Check the connection.

Turn on the switch.

Adjust the volume control knob.

Connect audio sources correctly.

Adjust the volume control knob.

Turn down the source volume and

MSS volume.

Problem

The MSS doesn’t

turn on.

No sound.

There is too quiet

sound of speakers.

Distortion of

sound.

If none of the above methods can solve the problem, please seek professional advice at your nearest service center.

Never attempt to repair the product yourself.

6. TROUBLESHOOTING

• Use the 2RCA to 2RCA signal cable (not included) to connect the MSS to a TV, DVD/CD-players. To do

this, use the signal cable to connect

• To connect the MSS to a TV, DVD/CD-players, use the 2RCA to 2RCA signal cable (not included).

For this at first plug the RCA jacks of the signal cable into input connector AUDIO INPUT of subwoofer

c, and the other RCA jacks of cable should be plugged into TV or DVD/CD-player audio outputs as

shown in Fig. 2.

• Plug the power cord f (Fig. 1) on the rear panel of the subwoofer into an outlet.

• Set the master volume to minimum, turn VOLUME a counter-clockwise until it stops.

• Turn the power switch POWER d (position ON) on the rear panel of the subwoofer. Power LED will

illuminate.

• Turn on your audio source.

• Adjust the master volume level by turning the VOLUME knob a. Adjust the subwoofer volume level by

turning the BASS knob b. By turning the knobs clockwise master volume level/subwoofer volume level

increases, while by turning counter-clockwise it is reduced.

Notes: If you don’t use MSS for a long time, make sure the device is turned off, check POWER

switch and unplug the power cord. Use the soundcard Line&Out port to improve sound quality.