VIEGA Advantix Vario в комплекте дизайн-вставка для трапа 704360 00019758 паспорт онлайн [19/50] 862107

3 Handling

3.1 Assembly information

3.1.1 Important note

Before assembly:

n Check if the drainage capacity of the model chosen is sufficient for

the arising water volume

Chapter 2.2.3 „Drainage capacity“

on page 9.

n In the case of the connection of two or three shower channels:

Observe the information for dimensioning of collective

lines

Chapter 2.2.3 „Drainage capacity“ on page 9.

n An adequate level of floor covering stability must be guaranteed

Chapter 2.3.3 „Technical data“ on page 15. This can be achieved

either through an adequate covering of screed or another alternative

solution. Relevant measures must be considered before mounting.

n The dimensions of slots and recesses must be in compliance with

the regulations from section

„Regulations from section: Important

notes“ on page 8.

During assembly:

n Observe installation dimensions.

n For barrier-free showers:

Position the shower channel in such a way that wheelchair wheels

can only cross it at right angles. Viega recommends mounting the

shower channel as close to the wall as possible.

n Do not use mounting adhesive older than 18 months.

n Position the shower channel in such a way that the grate is remov‐

able.

After assembly:

n The shower channel must be fully lined with mortar.

n The sealing accessories should be given to the person responsible

for the bonded sealing (e. g. tiler).

n Coordinate all relevant installation details, especially regarding the

bonded sealing, with those responsible for the subsequent work.

3.1.2 Tools and materials

n Spanner size 13

n Hand saw (saw blade maximum 1.5 mm)

n An Allen key in each of the sizes 2.5 and 3

n Drill, 6 mm

n Tool for the removal of the grate (e. g. model 4965.90,

art. no. 689 704)

Special tools

Handling

Advantix Vario base unit, for Advantix Vario shower channel, can be cut to length continuously 19 from 50