Home
Главная
Ridgid
Клуппы электрические
44933
Инструкция к товару Страница: 8

Ridgid 44933 Инструкция к товару онлайн [8/374] 864600

ng. This contamination could cause corrosion and pre-

mature failure. Careful evaluation of materials and meth ods

for the specific service conditions, including chemical and

temperature, should be completed before any installation

is attempted.

Pre-Operation Inspection

WARNING

Before each use, inspect power drive and correct

any problems to reduce the risk of serious injury

from electric shock, crushing injuries and other

causes and prevent power drive damage.

1. Make sure that the power drive is unplugged.

2. Clean any oil, grease or dirt from the power drive and

support device, including the handles and controls.

This aids inspection and helps prevent the machine or

control from slipping from your grip.

3. Inspect the power drive and support arm for the fol-

lowing:

• Damage or modification to the cord and plug.

• Proper assembly, maintenance and completeness.

• Damaged, misaligned or binding parts.

• Proper operation of two-step momentary contact

ON/OFF switch (Figure 5).

• Support arm gripping teeth are clean and in good

condition. Teeth can be cleaned with a wire brush.

• Presence and readability of the warning label.

• Any other condition which may prevent safe and nor-

mal operation.

If any problems are found, do not use the power

drive or support device until the problems have been

repaired.

Figure 5A – Two Step Momentary Contact ON/OFF Switch

Figure 5B – Two Step Momentary Contact ON/OFF Switch

4. Inspect the cutting edges of the dies for wear, defor-

mation, chips or other issues. Dull or damaged cutting

tools increase the amount of force required, produce

poor quality threads and increase the risk of injury.

5. Inspect and maintain any other equipment being

used per its instructions to make sure it is functioning

properly.

6. Following the Set Up and Operation instructions,

check the power drive for proper operation.

• Move the F/R (Forward/Reverse) switch to the F

position. Depress and release the ON/OFF switch

(Figure 5). Confirm that the power drive rotates in

the clockwise direction (see Figure 6) and stops

when releasing the switch.

• Repeat the process for the REVERSE (counter-

clockwise) operation. If the power drive does not

rotate in the correct direction, or the ON/OFF switch

does not control the machine operation, do not use

the machine until it has been repaired.

Change position of the F/R slide switch only

when the ON/OFF trigger switch is released. Allow the

power drive to come to a complete stop before reversing

the direction with the F/R slide switch. This will reduce the

risk of power drive damage.

• Depress and hold the ON/OFF switch. Inspect the

moving parts for misalignment, binding, odd noises

or any other unusual conditions. Release the ON/OFF

switch. If any unusual conditions are found, do not

use the machine until it has been repaired.

Figure 6A – F (FORWARD) (Clockwise) Switch Position

999-999-476.09_REV. F

600-I/690-I Power Drives

NOTICE

1. Push Forward

OFF

. Pull Up

Ridgid 44933 Инструкция к товару онлайн [8/374] 864600

Похожие устройства