Atlantic Vertigo Steatite 30 821359 [11/40] Maintenance

TROUBLESHOOTING

When a malfunction occurs, the user interface of the appliance can display an error code.

Fault (LED status)

Meaning

Remark

2 successive flashes of one shower sign,

3 sec. of pause, 2 successive flashes …

Error 3 :

Probe fault

Change probe

2 successive flashes of 2 showers signs,

3 sec. of pause, 2 successive flashes …

Error 3 :

Probe fault

(Differentiation)

4 successive flashes of one shower sign,

3 sec. of pause, 4 successive flashes …

Error 9:

Relay or PCB fault

Change PCB

MAINTENANCE

Before removing the plastic cover, make sure the power is turned off to avoid any risk of injury or

electric shock.

1. USER MAINTENANCE

Operates once a month the discharge of the safety valve to prevent scaling deposit and verify that the

safety device is not blocked. If this is not done, damage may be caused and the guarantee invalidated. For

an installation with a booster pump; before starting up, after a long period of disuse, turn the rotor following the

advice in the manufacturer’s instructions.

2. MAINTENANCE BY A QUALIFIED PERSON

- Scaling: Remove the scale sludge. Do not scrape or hammer the lime scale deposited on the casing, as this

may damage the lining.

- Magnesium anode: change the magnesium anode every 2 years or when its diameter is lower than 10 mm.

- Heating element: the replacement of a sheathed heating element involves draining of the water heater and

replacement of the flange gasket. Reassemble the heating element, reasonably tight nuts (cross tightening),

check that there is no leakage after the first heating-up, tighten again if necessary

- Drain: Turn off power and cold water supply. Open hot water taps and drain valve of the safety device.

Spare parts list: thermostat, flange gasket, heating element, heating light indicator, magnesium anode,

connection wires, electric switch. The guarantee requires genuine manufacturer’s parts to be used.

Advice to the user

 When the water has a TH > 20°f, it is recommended that this be treated. When a softener is used, the

water hardness must remain above 15°f.

 In case of prolonged absence, especially in winter, drain your appliance following the procedure above.