Piusi K900 METER 3in BSP F0049900B Инструкция онлайн [50/60] 865689

M0158B IT | en

50 /6 0

Installation, use and maintenance

OPERATION Display

Connﬁguration

NONE

K900 in normal mode, not in counting mode

LONG CAL KEY KEYING

K900 enters calibration mode, shows “CAL” and displays the calibration factor being

used instead of the partial. The words “Fact” and “User” indicate which of the two fac-

tors (factory or user) is currently being us

LONG RESET KEY KEYING

K900 shows “CAL” and the partial at zero.

K900 is ready to perform in-ﬁeld calibration by dispensing

LONG RESET KEY KEYING

We now go on to Direct change of the calibration factor: the word “Direct” appears

together with the Currently Used calibration factor. In the boom le part of the dis-

play, an arrow appears (upwards or downwards) deﬁning the direction (increase or

decrease) of change of the displayed value when subsequent operations 5 or 6 are

performed

SHORT RESET KEY KEYING

Changes the direction of the arrow. The operation can be repeated to alternate the

direction of the arrow.

BSHORT/LONG CAL KEY KEYING

The indicated value changes in the direction indicated by the arrow

- one unit for every short CAL key keying

- continually if the CAL key is kept pressed. The speed increase rises by keep-

ing the key pressed.

If the desired value is exceeded, repeat the operations from point (5).

LONG RESET KEY KEYING

K900 is informed that the calibration procedure is ﬁnished.

Before performing this operation, make sure the indicated value is that required

NO OPERATION

At the end of the calculation, the new USER K FACTOR is shown for a few seconds,

aer which the restart cycle is repeated to ﬁnally achieve standby condition.

IMPORTANT: From now on, the indicated factor will become the calibration factor used

by the meter and will continue to remain such even aer a baery change

NO OPERATION

K900 stores the new calibration factor and is ready

for dispensing, applying the newly deﬁned USER K FACTOR.

L CONFIGURATION