Hilti NUN 054 IE-A22 чемодан 2235767 Инструкция к товару онлайн [13/76] 871380

*2207121*

2207121 English 7

4.2 Battery

Battery operating voltage

21.6 V

Ambient temperature for operation

−17 ℃ … 60 ℃

Storage temperature

−20 ℃ … 40 ℃

Battery charging starting temperature

−10 ℃ … 45 ℃

5 Operation

5.1 Preparations at the workplace

CAUTION

Risk of injury by inadvertent starting!

▶ Before inserting the battery, make sure that the product is switched off.

▶ Remove the battery before making any adjustments to the power tool or before changing accessories.

Observe the safety instructions and warnings in this documentation and on the product.

5.2 Charging the battery

1. Before charging the battery, read the operating instructions for the charger.

2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.

3. Use an approved charger to charge the battery.

5.3 Inserting the battery

CAUTION

Risk of injury by short circuit or falling battery!

▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product

are free of foreign matter.

▶ Make sure that the battery always engages correctly.

1. Charge the battery fully before using it for the first time.

2. Push the battery into the battery holder until it engages with an audible click.

3. Check that the battery is seated securely.

5.4 Removing the battery

1. Press the battery release buttons.

2. Remove the battery from the tool.

5.5 Fitting the crimping / pressing or cutting jaws 2

WARNING

Risk of injury! Unintentional starting.

▶ Remove the battery before fitting, changing or removing the crimping /pressing or cutting jaws.

Never operate the crimping / pressing tool without crimping / pressing or cutting jaws in place.

1. Remove the battery and select the most suitable crimping / pressing or cutting jaws.

2. Press the locking pins.

3. Rotate the locking pins counterclockwise as far as they will go.

4. Pull out the locking pins.

5. Fit the crimping / pressing or cutting jaws.

6. Push the locking pins in until they engage.