Zalman ZM-GWB2 [6/7] Bolt b

4) Installing the VGA Water Block

Place the VGA Water Block and the clip on

the center of the VGA chipset. Screw each

bolt B on each nipple slightly, and tighten

each bolt B a few turns at a time while

alternating between the two until the Clip

ends are completely pressed against the

Nipples.

Notes)

Make sure that the Water Block’s base

and the VGA Chipset are completely in

contact with each other.

5) Installing the VGA Card

Insert the assembled VGA card into the

motherboard’s AGP (or PCIe) slot. Use the

Fixing Bolt to fix the VGA card on to the

computer case. If the VGA card has an on-board

power connector, remember to plug in the

power cable.

6) Installing the Tubes and the Tube Clamps

Plug the tubes over the VGA Water Block’s

fittings and install the Tube Clamps.

Note 1)

Use a proper tool (e.g. cutting nipper)

when installing the Tube Clamps.

Note 2)

Hold the VGA Water Block with one hand

while installing the Tube Clamps so that

the Water Block does not move around.

※

The specifications of any product may change without prior notice to improve performance.

Bolt B

Clip

Nipple

VGA Chipset

Fixing Bolt

Tube

Tube Clamp