KIWI KHAG-4114 Руководство по эксплуатации онлайн [6/68] 876498

Safety warnings specific for Grinding and Abrasive Cutting-Off operations

• Use only wheel types that are recommended for your power tool and the specific

guard designed for the selected wheel. Wheels for which the power tool was not

designed cannot be adequately guarded and are unsafe.

• The grinding surface of the centre depressed wheels must be mounted below

the plane of the guard lip. An improperly mounted wheel that projects through

the plane of the guard lip cannot be adequately protected.

• The guard must be securely attached to the power tool and positioned for

maximum safety, so the least amount of wheel is exposed towards the operator.

The guard helps to protect operator from broken wheel fragments, accidental

contact with wheel and sparks that could ignite clothing.

• Wheels must be used only for recommended applications. For example: do not

grind with the side of the cut-off wheel. Abrasive cut-off wheels are intended for

peripheral grinding; side forces applied to these wheels may cause them to

shatter.

• Always use undamaged wheel flanges that are of correct size and shape for

your selected wheel. Proper wheel flanges support the wheel thus reducing the

possibility of wheel breakage. Flanges for cut-off wheels may be different from

grinding wheel flanges.

• Do not use worn down reinforced wheels from larger power tools. Wheels

intended for larger power tools are not suitable for the higher speed of a smaller

tool and may burst.

Additional safety warnings specific for abrasive cutting off operations

• Do not “jam” the cut-off wheel or apply excessive pressure. Do not attempt to

make an excessive depth of cut. Overstressing the wheel increases the loading

and susceptibility to twisting or binding of the wheel in the cut and the possibility

of kickback or wheel breakage.

• Do not position your body in line with and behind the rotating wheel. When the

wheel, at the point of operation, is moving away from your body, the possible

kickback may propel the spinning wheel and the power tool directly at you.

• When wheel is binding or when interrupting a cut for any reason, switch off

the power tool and hold the power tool motionless until the wheel comes to a

complete stop. Never attempt to remove the cut-off wheel from the cut while the

wheel is in motion otherwise kickback may occur. Investigate and take corrective

action to eliminate the cause of wheel binding.

• Do not restart the cutting operation in the workpiece. Let the wheel reach full

speed and carefully re-enter the cut. The wheel may bind, walk up or kickback if

the power tool is restarted in the workpiece.

• Support panels or any oversized workpiece to minimize the risk of wheel

pinching and kickback. Large workpieces tend to sag under their own weight.

Supports must be placed under the workpiece near the line of cut and near the

edge of the workpiece on both sides of the wheel.

• Use extra caution when making a “pocket cut” into existing