Home
Главная
Brayer
Термопоты
BR1099
Руководство по эксплуатации Страница: 11

Brayer BR1099 Руководство по эксплуатации онлайн [11/56] 879075

will be displayed in symbols (18) (continuous water

supply).

4. Press the on/o󰀨/water supply button (14) «

» to

conrm.

5. The thermopot will enter calibration mode and

automatically exit after completion.

• The calibration mode time is about 4-5 minutes.

During calibration, water will be supplied to the

installed container (at least 3 liters).

«RESET» BUTTON

• If an emergency situation occurs and the heating

element overheats, the thermal switch will be on and

the thermopot will be switched o󰀨.

• Unplug the unit, let the thermopot cool down for

20-30 minutes, then lift the tray (1) and remove it,

remove the grid (2), pour the water out from the tray

(1).

• Turn the tray over (1) and remove the key to press

the reset button.

• Remove the water tank (6).

• Insert the key into the opening of the reset button (8),

slightly press the key until the characteristic click of

switching the thermal switch on.

• Reinstall the water tank (6).

• Fill the tank (6) with water, plug the power cord into

an electrical outlet, turn on the thermopot and check

its operation.

• If the thermopot is not swtiched on, this may

indicate another malfunction, in which case contact

be displayed, add water to the tank (6) and continue

using the device.

Notes:

- in the case of pouring a small amount of water,

the temperature may di󰀨er slightly from the digital

temperature readings (19). In this case, it is

recommended to preheat the container into which

the water will be supplied;

- the ambient temperature may change periodically,

which may lead to slight inaccuracy in the water

supply. The volume of water supplied may di󰀨er by

up to + - 15% from the digital readings (18);

- the thermopot has a memory function if the power

cord plug is inserted into an electrical outlet. If you

unplug the power cord from the electrical outlet,

the settings will be reset and you will need to re-

enter the desired water temperature and volume.

CALIBRATION

• If you nd that the water temperature and volume are

not accurate enough, follow these steps:

1. Fill the water tank (6) to the maximum level.

2. Place a container under the water drain spout (3)

into which you can collect all the water from the

tank (6) (at least 3 liters). To make it easier to install

the container, you can remove the drip tray (1).

Plug the power cord into an electrical outlet.

3. Press and hold the button (16) «

» for 3 seconds,

«AUT» will be displayed in symbols (19), «000»

Brayer BR1099 Руководство по эксплуатации онлайн [11/56] 879075

Похожие устройства