Gaggenau AI 280 [20/24] Installation

Installation

Note:

the extractor hood is to be installed to a kitchen

ceiling or suspended ceiling. Ensure that the ceiling

is capable of providing a firm hold for a maximum

weight of hood and accessories of 45 kg.

Before marking the securing holes, make sure that

no electricity wires or water pipes or other wires/

pipes are laid at the drilling points in the ceiling.

Before installation check the enclosed wall plugs

and screws are suitable for your ceiling. If

necessary use special wall plugs.

Installation of the extractor hood:

1 Using the drilling template mark the position of

the screws on the ceiling.

2 Drill 4 holes Ø 8 mm for the wall plugs. Push

the plugs flush with the ceiling.

3 Turn two screws to a 10 mm gap. Both screws

are placed in a position, in which at a later

stage of the installation the key-holes of the

supporting frame are found (namely back left

and front right from the control panel of the

hood).

4 Adjust the support frame to the desired height

and secure with 8 screws (12 screws for the

longer ventilation ducts). The length of the

support frame can be adjusted in steps of

20 mm.

Note:

ensure that the minimum distance between the

hob and the extractor hood is maintained -

600 mm for an electric hob and 700 mm for a

gas hob.

Circulating air mode only: there are four brackets,

which fix the circulating air switch module to the top

of the support frame. These should be bent outward

in a 90° angle.

346

200

Circulating air mode only