Gaggenau AI 280 Инструкция по эксплуатации онлайн [22/24] 106862

7 Slide the extractor hood into the on the side of

the support frame (Note: take care not to trap

the mains connecting cable) and immediately

secure the hood with 4 screws.

8 Screw the cover plate back on the rear of the

support frame. The cover plate is important for

the stability of the frame.

9 Connect the air outlet pipe to the extractor

hood and to the exhaust air pipe on the ceiling

(to the circulating air switch module for

circulating air mode).

10 Establish the electrical connection.

11 Pull the protective film off the chimney’s trims

(if applicable).

12 Avoid damaging the sensitive surfaces when

installing the ventilation ducts.

13 Secure the top chimney duct unit which has no

magnetic strips with 2 screws on the top of the

support frame.

14 The second top chimney duct (which has

magnetic strips) should be slightly bent open,

in order to slide over the first chimney duct

easily. Adjust (leave no gap) and fix with

2 screws to the top of the support frame.

15 Place the bottom chimney duct unit which has

no magnetic strips on the extractor hood. The

second bottom chimney duct (which has

magnetic strips) should be slightly bent open,

in order to slide over the first chimney duct

easily. Adjust to leave no gap.

16 Circulating air mode only: insert the activated

charcoal filter (see page 11). The activated

charcoal filter is not supplied with the

appliance.

17 Test that the appliance functions correctly.

Note: only dismantle the chimney ducts by hand. Do

not use a tool, this might damage the ventilation

ducts.