Brayer BR1028 серебристый/черный [7/0] Using the electric kettle
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Brayer BR1028 серебристый/черный [7/0] Using the electric kettle

Brayer BR1028 серебристый/черный [7/0] Using the electric kettle
7
EN
• Install the lid (9), make sure that the kettle lid is closed
tightly.
Note: it is recommended to install the tea infuser (7) in the
lid (9) during the rst boiling of water.
• Place the kettle on the base (4).
• Insert the power cord plug into the mains socket, you
will hear a sound signal.
STANDBY MODE.
• The button «100°С» illumination will light up blue and
start ashing. Press the «ON/OFF» button (3), the
button (1) illumination will light up red and the boiling
will start.
• When the water starts boiling, you will hear sound
signals, the button «100°С» illumination will glow blue,
the «ON/OFF» button (3) illumination will glow green.
Note: after the water boiling the button illumination will go
out in 5 minutes.
• Remove the kettle from the base and carefully pour out
boiled water into a suitable bowl.
• Remember that there is boiling water inside the kettle
ask (5), always hold the kettle only by the handle (11),
do not tilt the kettle sharply, in case of careless use of
the kettle you can get burns by hot water.
• Repeat the water boiling procedure several times.
ATTENTION! To avoid burns by hot steam, do not bend
over the spout (8).
• Hot water resulting from the rst boilings is not
recommended to consume, you may use it for domestic
needs.
USING THE ELECTRIC KETTLE
• Place the kettle on a solid steady at and non-slip non-
metal surface away from heat sources as far as possible
from the edge of the surface.
WATER BOILING
• Take the handle (10), pull it upwards and remove the lid
(9).
• Fill the kettle with water not below the mark «MIN» and
not above the maximal mark «MAX» (6).
• Close the lid (9) and put the full kettle on the base (4).
Note: if you are not going to brew the tea directly in the
kettle ask (5), do not install the tea infuser (7) in the lid (9).
• Insert the power cord plug into the mains socket, you will
hear a sound signal, button «100°С» illumination will light
up blue and start ashing.
• Press the «ON/OFF» button (3), the «ON/OFF» button
(3) illumination will light up red and the boiling process
will start.
• When the water starts boiling, you will hear sound
signals, the button «100°С» illumination will glow blue,
the «ON/OFF» button (3) illumination will glow green.
• If it is necessary to switch the kettle o󰀨, press the On/O󰀨
button (3) «ON/OFF».

Содержание

Похожие устройства

Скачать