Philips SCD465 [7/132] English

Except for the battery compartments, do not open the housing of the baby unit and parent

unit in order to prevent electric shock.

Only use the adapters supplied.

If one of the adapters is damaged, always have it replaced by one of the original type in order

to avoid a hazard.

The adapters contain a transformer. Do not cut off the adapters to replace them with other

plugs, as this will cause a hazardous situation.

Since continuous transmission is prohibited, you only hear your baby when it makes sounds.

The antennas on both units are xed. Do not pull at them or try to remove them.

Preparing for use

Baby unit

You can use the baby unit from the mains or on batteries. Even if you are going to use the unit from

the mains, we advise you to insert batteries. This guarantees automatic back-up in case of mains

failure.

Mains operation

1 Put the small plug in the socket on the baby unit and put the adapter in a wall socket. (Fig. 2)

Battery operation

1 Unlock the battery compartment lid by turning the locking knob with a coin. Then remove

the lid. (Fig. 3)

2 Insert four 1.5V AA batteries. (Fig. 4)

Make sure the + and - poles of the batteries point in the right direction.

3 Close the battery compartment lid by turning the locking knob with a coin.

Replace the batteries when the power-on light blinks red.

Make sure your hands and the unit are dry when you insert the batteries.

Note:Do not mix old and new batteries or different types of batteries.

Note:Remove the batteries if you are not going to use the baby unit for a month or more.

Note:If the batteries are left in the unit when it is operated on mains power, check them for leakage

every six months.

Parent unit

The parent unit has a rechargeable battery pack that can be recharged in the charger. When the

battery pack is fully charged, you can use the parent unit cordlessly for 10 hours.

Note:The NiMH batteries in the battery pack only reach their full capacity after you have charged and

discharged them three times.

Mains operation

You can only use the parent unit from the mains if it is partly charged. If you want to operate the

parent unit from the charger, charge the batteries for about 30 minutes before you switch on the

unit.

Battery operation

1 Put the small plug in the socket of the charger and put the adapter in a wall socket. (Fig. 5)

2 Place the parent unit in the charger.

The charging light starts to burn red.

3 Leave the parent unit in the charger until the batteries are fully charged.

ENGLISH 7

4222.002.6422.1.indd 7 14-04-2006 08:51:54