Soundmax SM-SA6042 — эффективный автомобильный усилитель с защитой и настройками [3/28]

Превью страниц Страница 3 / 28

SOUNDMAX SM-SA6042

Features

 Class ''AB'' Technology MOSFET Power Supply

 Remote turn-on of the amplifier via car radio

 Variable crossover low and high pass filter (4 channels)

 Bass Boost (0dB~12dB), 50 Hz

 Regulator for input sensitivity

 Bridgeable mode

 Silver Plated RCA & Power, Speaker Terminal

 Overload, Thermal, Short Circuit Protection

 Power & Protection indicator

Precautions: Read First!

 If after reading the direction you feel uncomfortable about installing the amplifier in your car, or not

equipped or competent to do so, you should have the amplifier installed by an authorized installer.

It's your car!

 Negative battery terminal must be disconnected before any electrical connections are made.

 Be sure choosing a location that provides substantial ventilation for the amplifier.

 The most preferred locations would be in your car's trunk, under the front seats or on the back wall of

a truck.

 The location chosen should provide at least 2" of clearance above the amplifier for adequate

ventilation.

 If the amplifier is to be mounted vertically be sure that it is in a place where adequate air will flow

along the length of its heat sink fins for cooling.

 NEVER mount the amplifier up side down, this will cause the heat to rise back into the amplifier

causing thermal shutdown or possible permanent damage.

 NEVER mount the amplifier in a location that is subject to direct sunlight or exposed to moisture.

 Be sure to mount the amplifier to a strong, solid surface, which will not give way under the stress of a

sudden stop or accident.

 Make sure that the mounting screws will not penetrate the gas tank, brake and fuel lines, wiring or

other critical parts of your car when installed.

 NEVER operate the amplifier without the proper power and ground wire 10 gauge minimum.

 NEVER operate the amplifier without proper fusing. Fuse holder must be located with in 0.5 meters

from the battery. This fuse is to protect the car not the electronics. In case of a short, the fuse will