Tesy FEF 200S [6/13] English
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Tesy FEF 200S [6/13] English

Tesy FEF 200S [6/13] English
6
English
20. Do not place the power cord in a way that may
obstruct people’s movements and be trodden
over! Use only approved extension units with
this appliance, ones bearing a compatibility
sign.
21. Do not ever move the appliance by pulling it
by the cord! Do not use the cord for carrying
objects!
22. Do not bend the cord and do not rub it on
sharp edges; also, do not place it onto hot
plates or open re!
23. Never use the appliance in close proximity to a
bathroom, shower cabin or swimming pool!
Package After unpacking the appliance,
make sure it has not been damaged during
transportation and no parts are missing from
the set! In case you detect damage or missing
parts contact your authorized trader! Do not
throw away the original packing! It may be used
for storing and transportation in order to avoid
damage in future transportation. Dispose of the
packing materials in a proper way! Do not let
children play with the PE bags!
INSTALLATION AND OPERATION OF THE
APPLIANCE
t 5IFöSFQMBDFJTJOUFOEFEGPSVTFPOøPPSTPOMZ
t 5IFöSFQMBDFJTöUUFEXJUIDBTUPSTBOEIBOEMFT
to make moving from one room to another
easy. It is usually placed near a wall. The choice
between 1kW or 2 KW of heat emission is
provided by a heater placed in the lower front
part of the replace.
Note: When using the appliance in an
environment with very low background noise
level, it is possible to hear a noise related to the
working of the ame-like eect. This is usual and is
not a reason for worrying.
t 1MBDFUIFöSFQMBDFJOQSPQFSXPSLJOHQPTJUJPO
(as per the requirements in the safety
instructions) before connecting it to the
electric source.
t 5IFDPOUSPMTPGUIFBQQMJBODFBSFQPTJUJPOFE
behind a metal panel on the front side of the
replace. There are three keys for the selection
of heating settings
Key 1(I) An ON/OFF switch for the power
supply to the replace and the ame-like
eect.
Note: The key should be in ON (I) position of the
replace so that the appliance can work with or
without heating.
Key 2 (I) An ON/OFF switch for 1 кW heating
power.
Key 3 (II) An ON/OFF switch for 2 кW heating
power.
Note: The ame-like eect can operate either with
or without the emission of heat power
Light bulb replacement
There are two bulbs in the replace, both placed
behind the rear panel of the replace.
It is necessary to remove the two screws that hold
the rear panel in place, in order to gain access.
After removal of the screws, slide the rear panel.
Unwind the faulty bulb and take it out carefully.
Take a new one (make sure it is the same power
rate as the faulty lamp)and wind it .Be careful not
to wind the bulb too tight as there is risk of injury.
Place the rear panel back and screw the two
securing screws.
IMPORTANT: The electric bulbs are not covered by
the guarantee of the manufacturer and have to be
paid separately when replaced in a service centre.
Overheating protection:
This appliance is tted with protection thermo-
switch which actuates at high temperature (e.g.
when the air outlets are blocked).For the sake
of safety the thermo-switch does not restart
automatically. To restart it, disconnect the
cord from the wall socket, wait between 30 to
60 seconds and plug in the socket again. The
appliance will start working properly. If that does
not happen, check the inlet and outlet openings. If
they are in order (and provided that the appliance
has been regularly dusted and cleaned) contact
the service oce nearest to you.

Содержание

Похожие устройства

Скачать