Philips Pocket Memo 8000 [7/58] Set default parameter

7Barcode scanner conﬁguration guide

2 Set default parameter

Scan Set Factory Defaults to restore the factory default values listed in the table on page 5.

Parameter Menus 4 - 7

Set Default Parameter

Scan Set Factory Defaults to restore the factory default values listed in Table 4-1 on page 4-2.

Set Factory Defaults

LED On Time

Parameter # 88h

This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in 0.1

second increments from 0.50 to 25.5 seconds.

To set an LED On Time, scan the bar code below. Next scan two numeric bar codes beginning on page 4-73 that

correspond to the desired on time. Single digit numbers must have a leading zero. For example, to set an on time of 0.5

seconds, scan the bar code below, then scan the "0", "5" and "0" bar codes; to set an on time of 10.5 seconds, scan the bar

code below, then scan the "1", "0" and "5" bar codes. To change the selection or cancel an incorrect entry, scan Cancel on

page 4-74.

LED On Time

(Default: 3.0 sec.)