Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [190/555] 12053
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [190/555] 12053

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [190/555] 12053
Section 02 ENGINE
Subsection 11 (CYLINDER BLOCK)
1
R1503motr18A
1. Crankshaft locking tool
CYLINDER BLOCK
Cylinder Block Disassembly
Remove:
– Engine oil (refer to
LUBRICATION SYSTEM
subsection)
– Engine from vehicle (refer to
ENGINE RE-
MOVAL AND INSTALLATION
subsection)
– Cylinder head (refer to
CYLINDER HEAD
sub-
section)
– PTO housing (refer to
PTO HOUSING AND
MAGNETO
subsection)
– Starter gear and starter drive (refer to
PTO
HOUSING AND MAGNETO
subsection)
– Oil suction pump (refer to
LUBRICATION SYS-
TEM
subsection)
– Balancer shaft (refer to
BALANCER SHAFT
elsewhere in this subsection)
– Crankshaft (refer to
CRANKSHAFT
elsewhere
in this subsection)
– Piston with connecting rod (refer to
PISTONS
ANDCONNECTINGRODS
elsewhere in this
subsection).
Bearings
When bearings need to be removed from the
cylinder block, mark them to identify the correct
position at installation. See the following illustra-
tion for an example:
1
R1503motr37A
2
1. Mark on balancer shaft bearings
2. Mark on crankshaft bearings
Starter Drive Bearing
Check bearing no. 21 of starter drive assembly
no. 22 in cylinder block and replace it if damaged.
R1503motr40A
1
TYPIC
AL
1. Bearing of starter drive assembly
Starter drive bearing can be easily removed from
crankcase lower half using the a small slide ham-
mer such as the
SNAP-ON SMALL SLIDE HAMMER
(P/N CJ93B)
.
F01J0ZA
smr2009-026 167

Похожие устройства

Скачать