Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [332/555] 12053
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [332/555] 12053

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [332/555] 12053
Section 05 ELECTRICAL SYSTEM
Subsection 04 (CHARGING SYSTEM)
A17E0IB
-
+
1
32
Step 1: Disconnect battery charger from AC outlet
Step 2: Disconnect - lead
Step 3: Disconnect + lead
6. Test battery state of charge. Use a hydrometer.
A17E0JA
1
1. Hydrometer
7. If electrolyte level has dropped after charging,
fill with distilled water to UPPER LEVEL line.
After water is added, continue charging for 1 to
2 hours to mix water with electrolyte.
8. Reinstall caps and clean any electrolyte spillage
using a solution of baking soda and water.
NOTE:
Hand tighten caps then tighten an ad-
ditio
nal 1/4 turn using a 20 mm (3/4 in) socket.
Usin
g an other tool could damage the plastic
batt
ery caps.
WARNING
Battery electrolyte is caustic. To prevent
spillage, battery cell cap should be suffi-
ciently tight to properly seal.
Charging a Used Battery
WAR
NING
Never charge battery while installed in water-
craft.
For best results, battery should be charged when
it is at room temperature. A battery that is cold
may not accept current for several hours after
charging has begun.
Do not charge a frozen battery. If the battery
charge is very low, the battery may freeze. If
you suspect the battery to be frozen, move it to a
heated area for about 2 hours (or more if required)
to let it thaw out before charging.
WARNING
Always charge a battery in a well ventilated
area.
The time required to charge a battery will vary de-
pending on several factors, such as:
– Battery tem
perature: The charging time is in-
creased fo
r a cold battery as charging current
accepted b
y a cold battery will be lower than
for a warm b
attery. As the battery warms up,
it will acc
ept a higher rate of charge.
– State of charge: As a battery discharges, it
gives up its stored energy. The greater the dis-
charge, the longer it will take to fully recharge
it.
– Type of charger: Battery chargers vary in the
amount of voltage and current that they can
supply.
Charging a Very Flat or Completely
Discharged Battery
The battery charger used should have an ad-
justable charging rate. A unit which can be
adjusted in small increments is acceptable.
The batt
ery charger must be equipped with an am-
meter ca
pable of accurately measuring current of
less th
an 1 ampere.
Unless this procedure is properly followed, a good
battery may be needlessly replaced.
1. Measure the voltage at the battery posts with
an accurate voltmeter. If it is below 10 volts,
the battery will accept current at very low rate.
It could be some time before the charging rate
increases. Such low current flow may not be
detectable on some charger ammeters and the
battery will not seem to accept the charge.
2. Excep
tionally for this particular case, set the
char
ger to a high rate.
smr2009-033 309

Похожие устройства

Скачать