Suunto Stinger Инструкция по эксплуатации онлайн [93/120] 12765

6.2. MAINTENANCE

If left without care for an extended period, a thin film (often invisible to the eye) will

cover the unit. Much like the buildup on the glass of an aquarium, this film is the

result of organic contaminates found in both salt and fresh water. Suntan oil, silicone

spray and grease will speed up this process. As a result of this buildup, moisture will

be trapped next to the water contact and will not allow your Stinger to operate properly.

The water contact can be cleaned with a small brush (e.g. toothbrush).

IMPORTANT: The Stinger should be soaked, then thoroughly rinsed with fresh

water and then dried with a soft towel after each dive. Make sure that all salt crystals

and sand particles have been flushed out. Check the mineral crystal for possible

moisture or water. DO NOT use the Stinger if you detect any moisture or water

inside.

CAUTION!

 do not use compressed air to blow water off the unit

 do not use solvents or other cleaning fluids that might cause damage

 do not test or use the Stinger in pressurized air.