Philips CEM3100/12 [9/28] Get started
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Philips CEM3100/12 [9/28] Get started

Philips CEM3100/12 [9/28] Get started
7EN
3 Get started
Caution
• Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
If you contact the Consumer Care, you will
be asked for the model and serial number of
this apparatus. The model number and serial
number are on the bottom of your apparatus.
Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Install the car audio
These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any question regarding installation kits, consult
your local retailer.
Caution
• This unit is designed for negative ground (earth) 12 V
DC operation only.
• Always install this unit in the car dashboard. Other
locations can be dangerous as the rear of the unit heats
up during use.
• To avoid short-circuit: before you connect, ensure that
the ignition is off.
• Ensure that you connect the yellow and red power
supply leads after all other leads are connected.
• Ensure that all loose leads are insulated with electrical
tape.
• Ensure that the leads do not get caught under screws
orin parts that will move (e.g. seat rail).
• Ensure that all ground (earth) leads are run to a
common ground (earth) point.
• Use only the supplied mounting hardware for a safe
and secure installation.
• Improperfusescancausedamageorre.Whenyou
need to change the fuse, consult a professional.
Note on the power supply lead (yellow)
• When you connect other devices to this
apparatus, ensure that the rating of the car
circuit is higher than the total fuse value of
all the connected devices.
Notes on speaker connection
• Never connect speaker wires to the metal
body or chassis of the car.
• Never connect speaker wires with stripes
to one another.
Connection: for cars with ISO
connectors
Caution
• Ensure that all loose leads are insulated with electrical
tape.
Note
• Consult a professional to connect CEM3100 as
instructed below.
• The ISO male connectors are not supplied.
1 Connect the male connector to the unit.
2 Check the car's wiring carefully and
connect them to the the male connector.
Note
• Risk of danger! Please consult a professional to perform
the below steps!

Содержание

Похожие устройства

Скачать