Jetair CH MilanoE90X+П/ДУ [7/32] 2 3 4 5 f 6

Jetair CH MilanoE90X+П/ДУ [7/32] 2 3 4 5 f 6
J132
7
GB
which open flame appliances are installed. The vapour
ducting installation must comply with the applicable
norms in force. If the hood is being used in the outdoor
vented mode where other vented fuel-burning
appliances are installed, you must ensure there is a
sufficient supply of air to the room.
1) Do not attempt to check the filters when the hood
is in operation.
2) Do not obstruct any air outlets.
3) Do not touch the lamps or lamp diffusers after
prolonged use of the hood.
4) Do not flambé food underneath the hood.
5) Avoid leaving an open flame uncovered, as it could
damage the filters and increase the risk of fire.
6) Never leave frying food unattended to prevent hot
oil from catching fire.
7) Disconnect the hood from the electrical mains
before performing any maintenance operations.
8) The manufacturer will not be held responsible for
any damage caused due to failure to comply with
the above warnings.
12 34 5F6
CONTROLS AND FUNCTIONS
1 = MOTOR STOP
2 = DECREASES THE SPEED
3 = INCREASES THE SPEED
4 = 5'/15' TIMER
5 = FILTER RESET
6 = ON/OFF LIGHT
F = SATURATED FILTER LED
- BUTTON 4: Activates and deactivates the timer.
Automatically turns off at the selected speed.
LED on = timer activated
Duration 5'/15'
- BUTTON 5: After having replaced the coal filters, press
this button for at least 3 seconds until the light turns
off.
- BUTTON 4+5: Remote control code programming.
Keep both buttons pressed down for at least 3
seconds. A beep will indicate the programming
mode has been accepted.
Without letting go of the buttons, press one of the
remote control buttons. A beep will indicate the code
has been accepted and stored.
- LED F: Indicates that the coal filter is saturated.
This is also indicated when the hood is used in vented
mode.
- REMOTE CONTROL:
1
st
button = ON /1
st
Speed/2
nd
Speed/3
rd
Speed/4
th
Speed/OFF
2
nd
button = Timer ON/OFF
3
rd
button = Light ON/OFF

Похожие устройства

Скачать