Kramer Yarden IH-1 [13/18] Installing the speaker

Yarden IH-1 - Installing the Speaker

5.2 Installing the Speaker

To install the hidden speaker inside the wall:

1. Check that there is no infrastructure or studs behind the wall where you want

to locate your speaker.

2. Place the cut out template on the wall in the correct location.

3. Mark the opening in the correct location by tracing the template.

4. Cut out a hole or small area within the marked template.

Initially, you can cut a smaller area inside the marked hole just to be sure that the area

behind the wall is clear. To do so insert a piece of “L-shaped” wire into the smaller

opening and rotate it. If the wire hits any obstacle which prevents you from installing the

speakers, you will need to move the template and test the area behind the wall again.

5. Cut out the full-sized opening according to the template.

6. Route the wiring from the amplifier to the speakers’ cut out holes, taking care

not to place them next to electrical wires or at least at a distance of about two

feet from an AC line.

7. Adjust each speaker to the appropriate tap setting (see Figure 4).

Set the tap according to the power requirements of the speaker based on its location in the

room (for example, a speaker located in a remote corner may require additional power)

Figure 4: Adjust Tap Selector

8. Connect the + (red) and – (black) wires to the + and – terminal block

connectors of the speaker.

Do not nail or staple the speaker wires.