Home
Главная
Sony
Компактные Фотопринтеры
UP-DR100
Инструкция по эксплуатации Страница: 5

Sony UP-DR100 Инструкция по эксплуатации онлайн [5/28] 144747

Introduction

Part Names and Functions

A ALARM indicator (25)

Lights in green when the system is initialized, or in

red when an error, such as a paper jam, occurs.

B Information Display (14, 18, 25)

Displays the number of pages printed, or the

amount of paper and ink ribbon remaining.

Messages are displayed when an error or warning

condition occurs.

C Operation panel door

Pull the top edge to open the operation panel door.

Operation panel with door open

A EXEC Button

Press this button to print the gray scale adjustment

pattern.

B MENU Button (18)

Press to display the number of pages printed or the

amount of paper and ink ribbon remaining.

Pressing the MENU button changes the printer to

the off-line mode and turns the ONLINE indicator

off.

C Cursor Buttons (18)

Press these buttons to select the item to be

displayed on the information display.

D CALIBRATION button (16)

Press this button to adjust the gray balance.

D Maintenance door (22)

Open the maintenance door for cleaning the surface

of the paper. The roller used for removing the dust

accumulated on the surface of the paper is attached

to the door.

E ONLINE indicator (14, 18)

Lights in green when the printer is controlled only

by the computer in the on-line mode.

This indicator goes off when the printer goes off-

line, for example, when you press the MENU

button to display the number of pages printed or the

amount of paper and ribbon remaining.

F PRINT Indicator (14)

Lights in green while printing.

G Ventilation holes (22)

Behind the ventilation holes panel, there is a built-

in fan to prevent the thermal head from overheating

H FEED button (12, 15)

Press and hold this button for more than one

second immediately after you replace the paper

and ink ribbon in use. Several sheets of blank

paper are then fed through. In this way, soiled paper

at the beginning of the roll will be eliminated, and

paper improperly loaded at an angle will be

straightened in the paper path. Also, pressing the

FEED button for more than one second during

printing results in cancelling the number of

printings set and clearing the images stored in the

memory. The printer stops printing when the page

currently printing is completed and ejected.

I !POWER switch (14)

Press this switch to turn the printer on or off.

J Paper scrap tray (6)

A margin of about 10mm is put between the current

printout and the next printout from the paper roll.

This margin of paper is cut off and ejected into the

paper scrap tray.

K Paper Output Slot

Printed pages are output from the printer here.

L SCSI Connectors (50-pin, half pitch) (7, 8)

Connect the computer used to control the printer

and connect other SCSI devices with SCSI cables to

one of these connectors. The second connector is

used as a pass-through connector when daisy

chaining with other SCSI devices. If only one of the

SCSI connectors on the printer is used, the internal

terminator should be enabled by changing the

appropriate DIP switch setting, see “DIP Switch

Settings” (page 7).

M DIP Switch (7, 8)

Determines the SCSI device ID number of the

printer, and sets the internal terminator on or off.

See “DIP Switch Settings” (page 7).

N - AC IN (Power Source) Connector (8)

Connect the supplied power cord here.

Sony UP-DR100 Инструкция по эксплуатации онлайн [5/28] 144747

Содержание

Похожие устройства