Netis WF-2405 [11/59] How to restore factory configuration

Portable Wireless-N Router/AP User Manual

Description

Function

DEFAULT

Restore factory configuration

WPS

Enable WPS setting

AP-Router

Switch to AP-Router mode

Client

Switch to Client mode

Switch to AP mode

2.3. How to Restore factory configuration

If the router ever freezes in a setting change process or if you can’t access it because you can’t

remember the IP you have given it or other problem, you may have to utilize the reset button on

the back of the router to put it back to factory settings. You have to press and hole this button

for a few seconds (2-6s) with a pencil when it is working, then release and it will restore

settings to the factory configuration.

The other way to restore factory settings is through the same user interface used in setup.

Click on ‘System management’- ‘Restore’, and click on the ‘Restore’ button.

2.4. Hardware Installation Procedures

The Portable Wireless-N Router /AP can work at AP-Router, Client, and AP mode. Each mode

meets different requirements, you can select corresponding mode as you wish. So please

check which mode is that you want, then install your device following the procedures below.

2.4.1. AP-Router mode

The device works as wireless router under this mode. Wireless clients(Notebook, tablet and

smart phone..) can connect to Portable Wireless-N Router /AP via wireless, then access the

internet. Select the AP-Router mode and connect your device as figure 2-3.