Gigabyte ga-b85m-d3v [27/36] 5 peripherals

- 27 -

& Administrator Password

Allows you to congure an administrator password. Press <Enter> on this item, type the password, and

then press <Enter>. You will be requested to conrm the password. Type the password again and press

<Enter>. You must enter the administrator password (or user password) at system startup and when entering

BIOS Setup. Differing from the user password, the administrator password allows you to make changes to

all BIOS settings.

& User Password

Allows you to congure a user password. Press <Enter> on this item, type the password, and then press

<Enter>. You will be requested to conrm the password. Type the password again and press <Enter>.

You must enter the administrator password (or user password) at system startup and when entering BIOS

Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.

To cancel the password, press <Enter> on the password item and when requested for the password, enter the

correct one rst. When prompted for a new password, press <Enter> without entering any password. Press

<Enter> again when prompted to conrm.

2-5 Peripherals

& Initial Display Output

Species the rst initiation of the monitor display from the installed PCI graphics card, PCI Express graphics

card or the onboard graphics.

IGFX Sets the onboard graphics as the rst display.

PCIe 1 Slot Sets the graphics card on the PCIEX16 slot as the rst display. (Default)

PCI Sets the graphics card on the PCI slot as the rst display.

& XHCI Mode

Allows you to determine the operating mode for the xHCI controller in OS.

Smart Auto This mode is available only when the BIOS supports the xHCI controller in the pre-boot

environment. This mode is similar to Auto, but it adds the capability to route the ports

to xHCI or EHCI according to setting used in previous boots (for non-G3 boot) in the

pre-boot environment. This allows the use of USB 3.0 devices prior to OS boot. xHCI

controller enabling and rerouting should follow the steps in Auto, when previous boot

routs ports to EHCI. Note: This is the recommended mode when BIOS has xHCI pre-

boot support. (Default)