Gorenje ght 63 xc [31/36] Installation

EN 31

INSTALLATION

Building in

Check if the cabinet and the cut-out meet the dimension and ventilation

requirement.

Threat the sawn ends of wooden or synthetic worktops with sealing

varnish if necessary, to prevent moisture causing the worktop to swell.

Lay the hob upside down on the worktop.

Remove the protective layer from the sealing tape and apply the tape in

the groove of the aluminium profile or on the edge of the glass plate. Do

not stick tape round the corners, but cut 4 separate pieces to seal the

corners well.

Turn the hob over and lay it in the recess.

Secure the hob using the fasteners supplied.

In the case of worktops thinner than 35 mm a filler block has to be used

between the fasteners and the worktop. The screws must be screwed

into the pressed holes.

Connect the appliance to the mains. A short beep will be heard and all

the displays will light up briefly. The appliance is ready for use.

Check that it works properly. If the appliance has been wrongly

connected either a beep will sound or nothing will appear in the displays,

depending on the error.