Texas CG330B [58/120] Problemen opsporen

Texas CG330B [58/120] Problemen opsporen
www.texas.dk
58
15. Problemen opsporen
PROBLEM POSSIBLE CAUSE SOLUTION
The engine will not
start
1. No spark Inspect the spark. Dismount the sparking plug,
put the sparking plug cover on the sparking plug
and place the sparking plug on the metal
cylinder. Pull the starting cord and see if any
sparks appear from the tip of the sparking plug.
If there are no sparks you shall repeat this test
with a new sparking plug.
2. No fuel Push the prime bolt. If the problems continue
you must contact your dealer.
3. Drowned engine Dismount the sparking plug and turn the trimmer
around, so that the sparking plug hole turns
against the ground. Move the choke to “Run”
and pull the starting cord 10 to 15 times. Clean
the sparking plug and put it back in its place. If
necessary replace. Pull the starting cord three
times with the choke on the ”Run” position. If the
engine does not start turn the choke to the
“choke” position and proceed with normal
starting procedure. If the engine still does not
start, repeat the procedure with new sparking
plug.
4. You have to pull the starting
cord harder.
Contact your dealer.
The engine starts but
will not accelerate
The carburettor must be adjusted Contact your dealer.
The engine starts but
will only run with full
power by half choke
The carburettor must be
adjusted, repaired or cleaned
Contact your dealer.
The engine will not run
by full speed and
exhausts heavy
smoke.
1. Check the mixing condition of
the fuel.
Use new fuel with the correct mixing conditions.
2. The air filter is dirty. Clean or replace
3. The carburettor must be
adjusted.
Contact your dealer
The engine starts but
will not idle
The carburettor must be adjusted Contact your dealer.
The cord will not feed 1. The cord is melted Replace, The trimmer has been too close to
stones and walls.
2. Insufficient cord on the spool. Add cord.
3. Cord has been worn too short. Feed with cord while the cord house is by turns
pushed down and released.
4. The cord is entangled on the
spool.
Remove the cord from the spool and rewind.
5. The revolutions of the engines
are too slow
Feed the cord by full power.
Grass is entangled
around drive shaft
house and cord house.
1. High grass is cut in earth
height.
Cut the grass from above and downwards.
2. Full power is not applied Apply full gas.
The spool box is
difficult to turn
Threads are dirty, damaged or
full of grass.
Clean the threads and grease them. If
necessary replace the spool box.
Oil drips from the
exhaust.
1. Full gas is not applied Apply full gas
2. Check the mixing conditions of
the fuel.
Use new fuel and correct 2-stroke mixture
3. The air filter is dirty Clean or replace
4. Carburettor must be adjusted. Contact your dealer.

Содержание

Скачать
Случайные обсуждения