HansGrohe metris 3168000 [5/56] Assembly see page 46

Assembly see page 46

Fault Cause Remedy

Insuﬃcient water - Shower ﬁlter seal dirty - Clean ﬁlter seal between shower

and hose

- Non return valve hasn't moved

back

- Exchange non return valves

Mixer stiﬀ - Cartridge defective, calciﬁed - Exchange cartridge

Mixer dripping - Cartridge defective - Exchange cartridge

Hot water temperature too low - Hot water limiter incorrectly set - Set hot water limiter

Instantaneous heater didn’t work - Flow limiter in handshower isn’t

removed

- Remove ﬂow limiter

- Filters are dirty - Clean the ﬁlter / exchange ﬁlter

- Non return valve hasn't moved

back

- Exchange non return valves

Technical Data

Operating pressure: max. 1 MPa

Recommended operating pressure: 0,1 – 0,5 MPa

Test pressure: 1,6 MPa

(1 MPa = 10 bar = 147 PSI)

Hot water temperature: max. 80°C

Recommended hot water temp.: 65°C

Centre distance: 150 ± 12mm

Connections G 1/2: cold right - hot left

anti-pollution function

Hansgrohe mixers can be used together with

hydraulically and thermically controlled continuous flow

heaters if the flow pressure is at least 0,15 MPa.

6 Safety Notes

6 Gloves should be worn during installation to prevent

crushing and cutting injuries.

6 The shower system may only be used for bathing,

hygienic and body cleansing purposes.

6 The hot and cold supplies must be of equal

pressures.

Installation Instructions

• The fitting must be installed, flushed and tested after

the valid norms.

• Prior to installation, inspect the product for transport

damages. After it has been installed, no transport or

surface damage will be honoured.

English