Robomow CITY110 [11/54] Chapter 1 base station perimeter wire setup

Chapter 1 - Base Station & Perimeter Wire Setup

1.1 Preparations

 Read carefully the Operating and Safety Manual prior to setup.

 It is recommended to mow your lawn using a conventional lawn mower and water the ground

before starting the setup for easier driving of the pegs.

 Confirm all parts for the setup are included (refer to ‘What’s in the Box’ page 10).

 During the setup you will also need the following tools:

1.2 Planning the Setup

1.2.1 Base Station Location

 Set it in the biggest plot or zone;

 It should be placed along the outer edge (if setup on the lawn area) or outside the lawn (refer

to paragraph 1.3.2 for external setup of the Base Station);

 In the back yard, where it is not visible to the street;

 In a shady spot (better for a longer battery lifetime);

 On a relatively level ground;

 Close to a wall socket (230V / 120V) – the length of the low voltage cable is 15m (50ft)

(Note: the length of the low voltage cable must not be changed).

Hammer

Combination

Pliers

Small flat and

Philips screwdrivers

ure 1.1

–

Tools required for the setup

IMORTANT INFORMATION! Before starting the setup, it is necessary to first

read this chapter in order to be aware of all setup rules and instructions so you are

able to determine the best location for the Base Station and the perimeter wire layout.

Wires leading to the next plot

are parallel and touching.

The gap between them

is for illustration onl

Base Station

location

Distance between

wires greater

than 1m (3ft)

Base Zone

Zone A

Figure 1.2 -

Base Station Location