Home
Главная
Meade
Телескоп
polaris 90 мм
Инструкция по эксплуатации Страница: 6

Meade polaris 90 мм Инструкция по эксплуатации онлайн [6/28] 159829

Meade polaris 114 мм Инструкция по эксплуатации онлайн [6/28] 159830

SETUP YOUR TRIPOD

The tripod is the basic support for your

telescope. Its height may be adjusted so that

you can view comfortably. Note: Number in

brackets, e.g., (3), refer to Fig. 1A and 1B

unless noted otherwise. The tripod is shipped

from the factory pre-assembled and needs

only the mount and accessory tray attached.

1.Spread the tripod legs out evenly apart.

2. Set the height of your tripod:

a. Rotate and loosen the tripod leg lock

thumbscrew (36) to unlock the sliding leg

extension (37).

b. Slide the inner portion of the leg (37) in or

out to the desired length.

c. Rotate and tighten the leg lock thumbscrew

(36) to re-lock the inner tripod leg.

d. Repeat for the other two legs so when

complete, the top of the tripod is level.

ATTACH THE ACCESSORY TRAY

using the large azimuth lock knob (30) at the

top of the tripod. Tighten to a firm feel.

ATTACH THE COUNTERWEIGHT SHAFT

AND COUNTERWEIGHT

1. Thread the counterweight shaft (6) into

the mounts declination axis (21, Fig. 3) until

it stops.

2. Remove the safety knob (8) and set aside.

3. Hold the counterweight (5) firmly in one

hand and slide the counterweight onto the

counterweight shaft (6) so it is about 2” from

the bottom of the shaft.

4. Secure in place by tightening the

counterweight lock knob (7).

5. Thread the safety nut (8) into the

counterweight shaft until tight.

Note: Make sure the safety knob (8) always

remains in place on the shaft. This safety

feature prevents the counterweight from

accidentally falling off the shaft.

The accessory tray attaches at the center of

the tripod legs and is a convenient place to

hold eyepieces and other Meade accessories

while observing, such as the Barlow lens.

To attach, place the hole in the center of the

accessory tray over the attachment point as

shown in Fig 2. Then rotate the tray until the

wings of the tray snap into place on the tripod

leg brace supports.

To remove the tray, rotate the tray so it

unlocks, then remove.

ATTACH THE MOUNT

Next, attach the mount body (2) to the tripod

by placing the base of the mount on top of the

tripod. Next, secure the mount to the tripod

Fig. 2

Looking at or near the Sun will cause irreversable damage to your eye. Do not point this telescope at or near the Sun. Do not look through the telescope as it is moving.

Meade polaris 90 мм Инструкция по эксплуатации онлайн [6/28] 159829

Содержание

Похожие устройства