Polaris Stream Pro 5.3 Инструкция по эксплуатации онлайн [22/32] 19304

III. Installation

Essential recommendations

 This device must be installed by a licensed

electrician. Before drilling, the electrician will

check that the wall does not have water pipes or

electric wiring that might be damaged.

 A heater for a shower should be installed on the

wall above the user's head—high enough so that

water will not spill on it, but not so high that the

user cannot reach to turn it on and off.

 The unit is to be connected to a single wire

power supply using a double pole automatic

switch rated for 32 А. The switch is to be set

separately from the unit.

 A protective cutout device is to be installed to

the power- supply circuit. Please contact an

authorized specialist.

 The heater's grounding wire should be connected

directly to the customer's grounding source, by

means of a separate grounding conductor;

grounding should be done in compliance with the

electrical regulations.

 Warning: Do not install the heater on a wall that

is not smooth and straight, nor on a wall where it

might freeze!

 The operation of this device requires 0.25 atmospheres of water pressure and a water

supply of 1.5 liters (ca. 1/3 of a gallon) per minute. It is adjusted to work with a

minimum water pressure of 0.25 atmospheres and up to a maximum water pressure

of 8 atmospheres.

 A pressure-relief valve is located at the bottom of the heater. In cases of malfunction,

this valve can release excess pressure of more than 8 atmospheres, that the heater can

stand. Also at the bottom of the heater, there is a pressure-relief hose, leading from

the valve; during the initial installation of the heater, it should be positioned towards

the sink or bathtub, or to any other appropriate drain leading to the sewer. After

repairing the malfunction, the valve-pin can be pressed manually, returning the valve

to its original state. In order to press the valve-pin, first the cover must be removed

from the base.

 In cases when the water does not flow properly or sprays in the wrong direction, the

rows of "pinholes" in the shower-head should be cleaned.

 The filter, located in the water entrance of the heater, should be cleaned in cases of

poor water supply.

 Do not get the heater wet when showering!