Polaris Stream Pro 5.3 Инструкция по эксплуатации онлайн [23/32] 19304

 Repairs of the heater or replacement of the electric wires should be done only by a

licensed electrician or at a certified electrical service centers. Before the repair, make

sure that the heater is disconnected from the electric power supply.

Mounting instructions

 To remove the right and left

covers from the heater's lid,

first pull off the cover (A)

from the bottom,

perpendicular to the base, and

then pull off the cover (B)

from the top.

 To remove the lid from the base, first

remove the 6 screws that connect the lid

to the base (3 under each cover).

 Put (but do not connect) the electric wire

into the heater via one of the appropriate

ducts, after opening the thin side of the

base to let the wire pass through (this

wire is not provided with the heater).

 Mount the heater on the wall in its

predetermined place, straight and level,

with the water inlets and outlets facing

downwards. To do so, mark the 4 spots

for the holes on the wall and drill the

holes using a 6 mm drill; place the

enclosed splay-winged, plastic pins

("dibbles") into each hole and connect

the heater firmly to the wall using the 4

enclosed screws.

 The hoses for the incoming and outgoing

water-supplies should be attached. There

are prepared, threaded holes for them,

measuring a straight 1/2 BSP. The inlet

is on the left of the heater and the outlet

should be connected to the pipe of the

right side. Do not reverse the hoses! The

input hose can be any suitable hose (it is

not supplied with the heater).

Warnings: