Polaris GAMMA 3.5 Инструкция по эксплуатации онлайн [18/23] 19396

6. Check how the water heater works by letting the water run through it and pushing the manual

switch.

7. Put the cover on the back part of the water heater and fix it with 2 screws after you make sure

that there is no leakage, and the electric circuit is working correct.

8. It is forbidden to input the water with temperature above 35

C; it may cause the overheating

of outlet water to level above 95

C. Additional instructions of setting the water heater with the power 3,5 kilowatts/220

volt.

1. The water heater is connected to a separate three conductor round cable with the diameter

2.5 mm. and fixed automatic load control for 16 amperes.

2. The threads of the wire are connected according to the colors. Watch carefully! A yellow

grounding wire must be connected right and sharply. It is very important to use special heat

resistant conductors because the temperature can be higher than 50 Celsius above zero.

3. The water heater is connected to a single phase power supply through the double -contact

switch. The following switch is set separately from the water heater.

4. The water heater must have a very strong grounding, the grounding lead must be painted in

a definite color not to mix with the other leads.

ATTENTION PLEASE! It is forbidden to switch on the appliance when there is a

danger for the freezing of the water in the water heater.

III. The order of working

The flow-type water heater works automatically. For the working of the water heater it is

recommended to have a pressure not less than 0.25 bar and the output flow of water not less

than 1,5 liters per minute. The maximum working pressure is 6 bars.

Before the beginning of working it is necessary:

 to plug the connector into the receptacle.

 to open the water flow with the help of the tap on the water inlet and turn on the

manual switch (there a signal will appear).

 to set the necessary temperature on the water outlet by changing the position of the

tap.

 if you want to switch the water heater off it is necessary to switch off the manual

switch ( the signal will die out), to cut the water off with the help of the tap on the

water inlet and disconnect the male plug with the electric receptacle

IV. Technical service regulation.

In the durative process of exploitation, when the warranty period is over, it is necessary to

make routine repairs once or twice a year.

- Turn the water heater off the main electrical supply

- Examine the water heater carefully , clean the water heater with the duster, check the water

pipes, remove the corrosion (if it is necessary to blow off) and cover with the layer of

protective lubrication.

ATTENTION!

Be careful! There mustn’t be any obstructions in the water outlet hose and shower- head.