Yealink SIP-T19 E2 Инструкция по работе с сервером Autoprovision онлайн [17/401] 166998

Getting Started

######################################################

## PPPoE(Except T41P/T42G Models) ##

######################################################n

etwork.pppoe.user =

network.pppoe.password =

######################################################

## Network Advanced ##

######################################################

##It enables or disables the PC port.0-Disabled,1-Auto Negotiation.

##The default value is 1.It takes effect after a reboot.

network.pc_port.enable =

##It configures the transmission mode and speed of the Internet (WAN) port.

##0-Auto negotiate

##1-Full duplex 10Mbps

##2-Full duplex 100Mbps

##3-Half duplex 10Mbps

##4-Half duplex 100Mbps

##5-Full duplex 1000Mbps (only applicable to SIP-T42G, SIP-T46G and SIP-T48G IP

phones)

##The default value is 0.It takes effect after a reboot.

network.internet_port.speed_duplex =

##It configures the transmission mode and speed of the PC (LAN) port.

##0-Auto negotiate

##1-Full duplex 10Mbps

##2-Full duplex 100Mbps

##3-Half duplex 10Mbps

##4-Half duplex 100Mbps

##5-Full duplex 1000Mbps (only applicable to SIP-T42G, SIP-T46G and SIP-T48G IP

phones)

##The default value is 0.It takes effect after a reboot.

network.pc_port.speed_duplex =

##It enables or disables the phone to use manually configured static IPv4 DNS when

Internet (WAN) port type for IPv4 is configured as DHCP.

##0-Disabled (use the IPv4 DNS obtained by DHCP) 1-Enabled

##The default value is 0.It takes effect after a reboot.

network.static_dns_enable =

network.ipv6_static_dns_enable =

###Only T41P/T42G/T46G Models support this parameter

network.vlan.pc_port_mode =

##It enable or disable to use A record of TTL

##The defalue value is 1;0-Disable 1-Enable

network.dns.ttl_enable =