Yealink TG100 [58/62] Blacklist

NeoGate TG Series User Manual

58/62

Enable Callback

hoose whether call back is enabled, you can

configure the advanced call back settings in part:

7.3.4.

Call Destination

Choose the destination trunk to route the call to

Hotline

When it’

s configred, this number will be dial via

destination trunk permanently

Two stage Dial

Enable it to get the customized two stage dial tone

before dial out, it’s disabled by default.

Outbound Dial Pattern

Outbound calls that match this dial pattern will use

this outbound route. Hover the pointer over to

read tips.

Strip digits from front

before dialing

Allows the user to specify the number of digits that

will be stripped from the front of the phone number

before the call is placed.

Prepend these digits

before dialing

These digits will be prepended to the phone

number before the call is placed

7.3.3 Blacklist

Blacklist is used to block an incoming/outgoing call. If the number of

incoming/outgoing call is listed in the number blacklist, the caller will hear the

following prompt: “The number you have dialed is not in service. Please check

the number and try again”. The system will then disconnect the call.

Figure 7-34

We can add a number with the type: inbound, outbound or both.

7.3.4 Callback Settings

NeoGate TG allows caller A to dial an inbound route number, and after hearing

the ring, A can hang up the call or wait for NeoGate TG to cut off the call, then