Moxa EDR-G903 [72/74] Cli command set user s manual layer 2 functions

CLI Command Set User's Manual Layer 2 Functions

4-32

rate-limit port-disable ingress rate { none | 44640 | 74410 | 148810 | 223220 | 372030 | 520840

| 744050 }

Syntax

Description

rate-limit Rate limiting

normal Rate limiting normal mode

port-disable Rate limiting port-disable mode

ingress Ingress rate limiting

egress Egress rate limiting

percentage Percentage correspond to current port speed

percentage Limit percentage, and will take effect at the percentage

0/3/5/10/15/25/35/50/65/85

rate Specify the rate

mode Specify the mode

bcast Limit broadcast frames

bcast-mcast Limit broadcast and multicast frames

bcast-mcast-dlf Limit broadcast, multicast and DLF frames

all All traffic

period Port disable period

period Seconds

Defaults 0 or none means unlimiting.

Command

Modes

Interface configuration

Usage

Guidelines

The percentage will only take effect at the 0/3/5/10/15/25/35/50/65/85 %.

For port disable mode, the port will be disabled when the ingress rate reach the specified packet

rate.

Examples router(config-if)# rate-limit percentage

<UINT:percent> - Limit percentage, and will take effect at the percentage

0/3/5/10/15/25/35/50/65/85

EDS-408A-1M2S-SC(config-if)# rate-limit ingress rate none none none none

router(config-if)# rate-limit port-disable ingress period 30

EDS-408A-1M2S-SC(config-if)# rate-limit port-disable ingress rate 148810

Error

messages

Cannot configure on trunk member port 1/1!

This setting cannot be applied on trunk port!

commands

show interfaces rate-limit